Mopar Suregrip Manual – Clutch

Download the 3.7MB PDF here: MoparSureGripManual.pdf

Leave a Reply Cancel reply

Dodge Dart Right-rear Fender rust repair
Rust issues on the Dodge Dart’s rightrear fender were getting pretty severe since last year, so the time had come to do something about it, as much as I hated it…! The damage was serious [more … ]

Share this:
Email
WhatsApp
Telegram
Black wheels for the Dart
The wheels on the Dart have been taking a beating about every winter when roadsalt collects and eats into their paintlayer. Overtime, the wheels had become ugly and shabby looking because of that. For a [more … ]

Share this:
Email
WhatsApp
Telegram
1973 Dodge Dart Rust repair
The time had come to start fixing a number of rust issues on the Dart. First up was the passenger-side floorboard. The floorboard was already rusted and in bad shape when I bought the car [more … ]

Share this:
Email
WhatsApp
Telegram
Dodge Dart – DynoDay #4
Had the Dodge Dart on the chassis-dyno again last monday at Ludwig Performance in Hillegom, The Netherlands. This is DynoDay number 4 already! The very first DynoDay with the 318ci engine ‘managed’ a shameful 145hp [more … ]

Share this:
Email
WhatsApp
Telegram
A500 / 42RH OD-unit rebuild
After the transmission it was time to tackle the overdrive-unit. This unit is the 4th gear (overdrive) in the transmission, and has its own set of clutch plates. Overdrive can only be ‘selected’ with the [more … ]

Share this:
Email
WhatsApp
Telegram
A500 / 42RH Rebuild project
Finally received the transmission repairkit to start the planned rebuild of the A500/42RH transmission I had bought earlier. The A500 (or also known as 42RH) transmission is based on Chrysler’s ‘904’-smallblock transmission. The A500 has [more … ]

Share this:
Email
WhatsApp
Telegram
Mopar Nats 2018 in Herten, Germany
Here’s a nice video-compilation of the 2018 edition of the Mopar Nationals 2018 in Herten, Germany.

Share this:
Email
WhatsApp
Telegram
Radiator flushing with citric acid
A recent cooling issue with the 496ci stroker engine in the 1960 Chrysler New Yorker let me to investigate the cooling system a bit closer. The car would run hotter than normal and highway driving [more … ]

Share this:
Email
WhatsApp
Telegram
360ci Compression Test #3
The first attempt to do a cranking compression test on the 360ci engine resulted in varying values simply because it was too difficult to press the tester tightly against a sparkplug hole and crank the [more … ]

Share this:
Email
WhatsApp
Telegram
Frame rail damage
A few years ago I had noticed some cracks in the frame rails on the driverside and just a tiny crack at the rightside frame rails. Now during the 360-engine swap I noticed the rightside [more … ]

Share this:
Email
WhatsApp
Telegram